Creating a One-line in EasyPower

JIM RAUB
over 3 years agoApril 26, 2015
07:21:84
If this is easy as it appears I've been wasting a lot of time with SKM. It appears you do a lot of sizing but my concern is selecting the cable used in a project and the X/R ratios inadvertently defaults to your data base. These guys, as you well know, are the determining factor in S.C. calculations. I normally use the manufacturers' data sheets for generators. Then calculated the three X/R ratios by hand.
Anonymous
7 days agoAugust 7, 2018

ABDUL MANNAN MOLLAH
about 2 years agoMay 29, 2016
07:21:87
Thanks to Easypower Initiators and team members. I am highly impressed on this software for easiness and friendly 

Engr Mannan
Consulting Engineer
01819126550
OBEIDANI
4 months agoApril 24, 2018
I already installed easypower software but its asking me to enter the authorization code, How could I get this code????
Ted
4 months agoApril 24, 2018
Did you sign up for a demo of the software? If so, you should receive an email with the instructions for using the demo. You can also contact support@easypower.com if you have questions with the demo installation.
Your comment